16 Aldebaran BFS bearing how to replace the XG




Exchange point of the bearing is two places of the side cover part and the spool shaft portion.






A lever under the side cover to remove the lock to move as indicated by the arrow, and remove the side cover.






Then, it can be decomposed into the reel body-side cover spool.






Of you to prepare the replacement bearing two and a bearing stopper ring precision flat-blade screwdriver to be used when removing the, spool bearing remover , it is the tweezers.






16 Aldebaran BFS of XG does not have a spool bearing on the mechanical brake in the knob . Bearing in the back inside of the mechanical brake knob exists, but the bearing of the arrow part Please do not touch that there is no relationship between the current bearing exchange .




Bearing How to replace the side cover part




First, remove the bearing stopper ring of arrows.






Precision against a flathead screwdriver as shown in the photo to a piece of the bearing stopper ring at the back of the magnet brake unit, can be removed and scoop up from the bottom while pressing a little to the inside of the bearing stopper ring.






At this time, since the bearing stopper ring and remove the bearing stopper ring forcibly corruption will occur, will go well and removed by pinching, etc. carefully with tweezers after removing the part.






After removing the bearing stopper ring and take out the genuine bearing.
At this time, the handle knob cap remover is easy to recommend because it can be taken out by hooking the bearing With such.






By removing the bearing stopper ring enables genuine bearing is taken out exchange.






To the side cover Install the bearing. In this case, it can be installed easily and push the bearing using a pair of tweezers.






After installing the replacement bearings, bearing stopper ring using the tweezers until it snaps into the groove.
Please try to be working again push the bearing to the back if the bearing stopper ring does not fit well.




Each part is the successful work completed if attached without any problems.




※ Note


It should be noted that, when performing these tasks, please do not remove the red circle part of the screw of the above photo . There is a small spring inside, the assembly will be very difficult once the decomposition.




Bearing exchange method of the spool shaft portion




Bearing of the spool shaft section also allows you to exchange With the spool bearing remover.






The removal of the shaft pin spool bearing remover you used.




※ attention




to this spool shaft pin there are differences in thickness in the left and right of.
Please working from the more narrow end of the spool shaft pin sure.

※ spool bearing remover more information on how to use, please refer to the product page.




When broken down here can remove the bearing from the spool, it allows bearing exchange.






After bearing mounting, again the shaft pin spool bearing remover Attach using.
At this time, mounting the shaft pin from those narrow end of the spool shaft pin to the spool shaft, so please attach by pressing the thicker the spool bearing remover.




It is work completion be attached properly spool shaft.






Finally, the assembly of the reel, please perform the operation check whether there is a problem.