Bearing exchange method of Revo LTX BF8



A lever under the side cover to remove the lock to move as indicated by the arrow, and remove the side cover.






Then, it can be decomposed into the reel body-side cover spool.






Of you to prepare the replacement bearing two and a bearing stopper ring precision flat-blade screwdriver to be used when removing the, spool bearing remover is.






It should be noted that, although we bearing is arranged in the mechanical brake in the knob, in the case of the Revo, the bearing is a bearing which does not rotate becomes free when you turn off the clutch.
Since the time of the cast will be bearing not rotating, distance does not change even if the exchange.
Therefore, does not the bearing exchange in the cut-fly tuning kit, there is an effect of improving the comfort, such as winding by exchanging the corresponding base bearings below.

⇒ 1030AIR HD Or 1030AIR Or 1030AIR BFS Or 1030ZR Or 1030ZHi




bearing how to replace the side cover part



First, remove the bearing stopper ring of arrows.






Precision a flathead screwdriver addressed as shown in the photo to a piece of the bearing stopper ring, you can remove and scoop up from the bottom while pressing a little to the inside of the bearing stopper ring.






In this case, bearing stopper ring can prevent the loss of parts and to work while pressing lightly with the opposite finger. Even if you if you lose unexpectedly spare bearing stopper ring We are also ready.






Bearing stopper ring after removal of the and take out the genuine bearing.
At this time, the handle knob cap remover is easy to recommend because it can be taken out by hooking the bearing With such.






By removing the bearing stopper ring enables genuine bearing is taken out exchange.






After installing the replacement bearings and snap it into the inside of the groove and push the bearing stopper ring finger.
Please try to be working again push the bearing to the back if the bearing stopper ring does not fit well.




Each part is the successful work completed if attached without any problems.




Bearing exchange method of the spool shaft portion



Bearing of the spool shaft section also allows you to exchange With the spool bearing remover.






The removal of the shaft pin spool bearing remover you used.




※ Note




At this time, the spool shaft pin of Aburiru there are differences in thickness in the left and right of.
Please working from the more narrow end of the spool shaft pin sure.

※ spool bearing remover more information on how to use, please refer to the product page.






When broken down here can remove the bearing from the spool, it allows bearing exchange.






After bearing mounting, again the shaft pin spool bearing remover Attach using.
At this time, attach the parts from those narrow end of the spool shaft pin to the spool shaft, so please attach by pressing the thicker the spool bearing remover.






Is the work completed by attaching the spool shaft.






Finally, the assembly of the reel, please perform the operation check whether there is a problem.