Shimano 12-13 Aix bearing method of replacing the DC unit of the sense DC



First, remove the side cover.
In addition, DC unit are attached to the side cover.




Remove the three screws that secure the side cover plate and the DC unit.






DC unit by removing the screws will be broken down into three parts of the photo.
When the decomposition so far enables the exchange of bearings.




In addition, the side cover plate side has attached a small spring and a sounding pin.
Please keep in mind so as not to lose the time of taking out the DC unit.






Bearing bearing stopper ring can be easily removed by using the such as flathead screwdriver because it is only been fixed in.
By removing the bearing stopper ring enables genuine bearing is taken out exchange.
It should be noted, bearing stopper ring Please use, for example, when the preliminary even that has been damaged or lost because the offers.

If the bearing is difficult to take out the handle knob cap remover you can easily exchange work be taken out as hooking using.


In, and secure again to the side cover of the DC unit.



First of all, you have to assemble the DC unit of 3 parts configuration first.






At this time, there is mounting in some parts orientation.
Small dent in the red circle the site of the photos I there's two points, this is please do attachment to come to the dial side.






To secure the DC unit is assembled to the side cover plate.
In this case, if the small spring and a sounding pin to the position of the red circle of the side cover plate side is properly attached please check.
And the tip of the sounding pin is please do the assembly to fit into the recesses in the red circle the site of the DC unit side.




In three screws to secure the DC unit.
Finally, when you install the side cover to the reel body, whether there is a problem with the rotation of the one-spool lever a click sound is depending on whether the lever operation to run smoothly please confirm.
Please check the position and orientation of each part is decomposed again if there is a sense of incongruity.

This work is complete if there is no problem.