Bearing method of replacing the 16 Antares DC

16アンタレスDCのベアリング交換方法

16 Antares DC will exchange there since it has a bearing is attached to the spool body and the DC unit.




Bearing exchange method of the spool body



To replace the bearing, which is attached to the spool body, so you must remove the shaft pin spool bearing remover will remove using.
Shaft pin is different from the thickness of the left and right, but it does not matter is pulled out from either.






※ If you do not have a spool bearing remover, we also sales and rental.
→ For more information about the spool bearing remover, please click here.






And pull out the shaft pin you can remove the bearing.
After, replace the bearing, is the work completed if able to re with a pin with a spool bearing remover.




DC unit inside of the bearing exchange method



First, remove the three screws that secure the reel unit and the DC unit, remove the cap in the middle portion of the DC unit.






Bearing bearing stopper ring can be easily removed by using the such as flathead screwdriver because it is only been fixed in.
By removing the bearing stopper ring enables genuine bearing is taken out exchange.
It should be noted, bearing stopper ring Please use, for example, when the preliminary even that has been damaged or lost because the offers.

If the bearing is difficult to take out the handle knob cap remover you can easily exchange work be taken out as hooking using.

After bearing exchange, carried out the assembly in the reverse order, it is the last work completed if there is no problem to check the rotation of the spool.