[Avail] SHIMANO Microcast Spool CNQ5018S, CNQ5036S for CALCUTTA CONQUEST 50S

Our Selling Price: US$51.07 [Regular Price: US$72.95]

Prices vary according to options.

Not available

Return & Exchange Policy

Item Description

　Regarding the stock of AVAIL product

It takes us two to three days to get ready to send Avail products
because we order them from the Avail factory.
Sometimes they might be out of stock at the timing of your order.
In the case of a stockout, we refund your purchase price immediately.

　Type and description

Avail Microcast Spool CNQ5018S
（The spool rim level is 1.8mm）
Avail Microcast Spool CNQ5036S
（The spool rim level is 3.6mm）

This model is for CALCUTTA CONQUEST 50S, 51S.

※NOT compatible with CALCUTTA CONQUEST 50 and 51
Either genuine centrifugal brake or special magnetic brake can be equipped.

　Spool colors

・GUNMETAL
・CHAMPAGNE GOLD

　Braking system options

With No brake
※When you just remove SVS from your genuine spool and use it, please choose here.
At the most reasonable price, you can try the performance of lightweight spool.

CALCUTTA CONQUEST

With a magnetic brake
※ Although the attachment would be difficult,
fine tuning of the magnetic brake is possible even with SHIMANO reel.

　Spec

｜Material

Spool : extra super duralumin
Shaft : stainless-steel

｜Compatibility

CALCUTTA CONQUEST 50S
CALCUTTA CONQUEST 51S

※NOT compatible with CALCUTTA CONQUEST 50 and 51

｜Weight

Microcast Spool CNQ5018S : 9.8g
(The weight ratio against genuine product approximately 72%)
Microcast Spool CNQ5036S : 9.5g
(The weight ratio against genuine product approximately 70%)

SHIMANO genuine spool : 13.6g

｜Line capacity

CNQ5018S　4Lb-40m：3Lb-50m
CNQ5036S　8Lb-45m：6Lb-70m：4Lb-110m

※The numerical value mentioned above is the result of measuring
by winding nylon line up to the edge of spool rim.

　Instruction Manual

｜How to replace SVS brake

CALCUTTA CONQUEST

Take SVS off the genuine spool.
The brake unit is press-fitted.
Loosen the unit by lifting little by little.
Then pull straight out from spool.
Please be careful not to damage the brake and scratch spool rim.

Press brake unit into Microcast Spool tightly.
Since the total weight of spool gets lighter, you will use less number of brake block.

※As for removing and also attaching, please do so on your own responsibility.

｜How to attach magnetic brake

Brake unit is required separately.

CALCUTTA CONQUEST

Take CONQUEST 101 as an example

CALCUTTA CONQUEST

Take the spool out
Please keep the genuine spool aside.

CALCUTTA CONQUEST

Microcast Spool and Microcast Brake SHSC-05A (optional product)

CALCUTTA CONQUEST

Attach the brake unit to SVS cover.
Pole pieces should be on the opposite side of the cover.
Press the unit to the end.

CALCUTTA CONQUEST

To adjust the brake, change the level of the head part by turning it.
There are different widths of screw thread between the two pictures above.
The brake force of the unit in the upper picture is stronger than the other below.

CALCUTTA CONQUEST

Put the whole unit into the reel to finish up.